Solution home Troubleshooting

Navigation Box

Navigation Box - Check learning process results
Check Navigation Box Learning: Check the value of the learned floor heights at any time in the NavBox “Device Calibration” area on the Hub under P198: ...
Tue, 14 Dec, 2021 at 2:58 PM
There was a power outage and the Nav Box is no longer displaying the floor numbers or arrows. Do I need to start the learning process again?
No, if the Nav Box had previously completed the learning process it will remember its floors. In the event of a power outage, the Nav Box will need to recal...
Wed, 26 Jan, 2022 at 2:27 PM
There is a DIP switch on the Nav Box. What do the switch positions mean?
Switches 1 and 2 are used for elevator shaft address selection. This allows you to select the shaft where the device is placed. From 1 to 4*. Switch 3 enab...
Wed, 26 Jan, 2022 at 2:27 PM
There is an ‘MKCAN SET’ on the PxP to ensure that the display is setup correctly on the CANbus using jumper switches. What do the switch positions mean? (PxP = PRP or PSP)
You must ensure that if your E-Motive PxP display is correctly configured on the CANbus. This can be configured by using the jumper switches ‘SEL’ and ‘TER’...
Wed, 26 Jan, 2022 at 2:29 PM
How do I enter the on-screen display (OSD) menu to start the learning process?
To activate the OSD menu, press both SW3 and SW 4 at the same time. These switches can be found at the back of the PxP/MxP/ATOM display or by using the magn...
Wed, 26 Jan, 2022 at 2:34 PM
I have installed the E-Motive display and Nav Box and ensured that the wired connections are correct, but when I start the learning process I keep getting the following message; ‘Self learn’ setting shows ‘Not applicable’.
This is due to the ‘Lift information input type - Serial’ being set incorrectly as ‘E-Motive 4 wire’, this needs to be changed to ‘MKCANBus’ using the OSD m...
Wed, 26 Jan, 2022 at 2:34 PM