There is a DIP switch on the Nav Box. What do the switch positions mean? : Avire - Helpdesk

There is a DIP switch on the Nav Box. What do the switch positions mean? Print

Modified on: Wed, 26 Jan, 2022 at 2:27 PM

Switches 1 and 2 are used for elevator shaft address selection. This allows you to select the shaft where the device is placed. From 1 to 4*.

Switch 3 enables manual initiation of learning mode without a display installed (this function is not recommended).

Switch 4 controls the MKCANbus termination resistor (end of line or through).

*Important - Shaft number must correspond to the other items connected along the MKCANbus e.g. PSP, PRP, DCP, DAU etc. Ensure this is the same as your display.

Did you find it helpful? Yes No

There is a DIP switch on the Nav Box. What do the switch positions mean? Print

Related Articles