There is an ‘MKCAN SET’ on the PxP to ensure that the display is setup correctly on the CANbus using jumper switches. What do the switch positions mean? (PxP = PRP or PSP) : Avire - Helpdesk

There is an ‘MKCAN SET’ on the PxP to ensure that the display is setup correctly on the CANbus using jumper switches. What do the switch positions mean? (PxP = PRP or PSP) Print

Modified on: Wed, 26 Jan, 2022 at 2:29 PM

You must ensure that if your E-Motive PxP display is correctly configured on the CANbus. This can be configured by using the jumper switches ‘SEL’ and ‘TER’.

SEL - By default, this is set to Pin 1 and 2 ("ON").

TER - By default, this is set to Pin 2 and 3. Change to Pin 1 and 2, if the PxP Display is either the first or last device on CANbus.

Did you find it helpful? Yes No

There is an ‘MKCAN SET’ on the PxP to ensure that the display is setup correctly on the CANbus using jumper switches. What do the switch positions mean? (PxP = PRP or PSP) Print

Related Articles