Solution home Troubleshooting

Panachrome+

The doors are not closing but there is nothing blocking them, why won’t they close?
Check the installation sheet to confirm correct installation including detector alignment. If this is correct, then there could be something is stuck to the...
Wed, 26 Jan, 2022 at 2:45 PM
One of the LEDs is not working can I buy a replacement light indicator?
The LEDs (Light Emitting Diodes) in the detectors are not replaceable.
Wed, 26 Jan, 2022 at 2:45 PM
I need to install Panachrome+ detectors statically. Is this possible?
Yes, Panachrome+ detectors can be mounted statically using the external door signalling input on the Panachrome+ Controller to determine when green/red indi...
Wed, 26 Jan, 2022 at 2:46 PM
There is a delay of 50/100mm when the door is closing before the green indicator changes to red. Is there a way to have the light change instantaneously without a delay?
Yes, an external signal activation provides the quickest response to indicate door movement.
Wed, 26 Jan, 2022 at 2:46 PM
What is ‘Failsafe’, How do I know if Panachrome+ conforms and can I tell if it is working?
Failsafe; If a fault occurs i.e. losing mains power, damage to the Panachrome+ Controller, extension cables or detectors, the doors will remain open in a sa...
Wed, 26 Jan, 2022 at 2:47 PM
Replaced P40 Plus/Panachrome to Panachrome+, the doors now open in reverse when detectors are triggered even though I have used the same door contact wires from the original Avire controller (N/O, N/C) why is the relay now switching differe
On the Panachrome and Pana40 they were labelled as they would be on the relays. Whereas on the Panachrome+ the labels are how the user would interact with t...
Wed, 26 Jan, 2022 at 2:47 PM
How do I turn on/off audio?
Audio settings for the Panachrome+ can be configured using the on-board controller configuration, simply enter the menu using the navigation buttons on the ...
Wed, 26 Jan, 2022 at 2:48 PM