Displays

The E-Motive display is showing a blue screen and no signal. What is the cause?

When the E-Motive display is showing a blue screen, this indicates that the display has entered sleep mode. When a lift signal is received, the screen will ...

Wed, 26 Jan, 2022 at 2:23 PM

When I send a new layout to my display from the Avire Hub the display is not updating. What do I do?

Updating the display requires the new layout to be saved to the local SD on the display. The most likely cause of this issue is a locked SD card. Check the ...

Wed, 26 Jan, 2022 at 2:25 PM

I have installed the E-Motive PRP display and the screen is working but it keeps switching off?

This is due to the E-Motive PRP display being set in ‘Power Mode Save’. This can be changed using the tact switches on the back of the screen, to turn ‘Powe...

Wed, 26 Jan, 2022 at 2:26 PM

I have installed an E-Motive CAR Indicator screen (C1L) and using it to display advertising, although this is installed within the lift CAR, I am not using it to display Lift Information or receive Lift signals. The screen is working OK, bu

If the screen has not been set as a Hall Indicator it will be expecting lift signals to prevent the display from entering sleep mode. To set the display as ...

Wed, 26 Jan, 2022 at 2:35 PM

I have installed an E-Motive iS2 display and I have a layout with a video playing. The video plays but then stops and goes blank.

The cause of the video stopping and going blank will be due the video BIT rate being too high for the iS2 display processor. For optimized iS2 display perfo...

Wed, 26 Jan, 2022 at 2:36 PM